Broadcast Tools DSC-20 Manual de Instalação descarregar pdf (Página 50)

Preliminary 8-2002 RSHD Smartcaster Installation Manual

supply to turn the power on and off. On ATX-style cases the power button connects to

the motherboard instead.

The replacement AT-style power supply probably came with not only the cable to the

power switch, but also had a new power switch attached to it. This will leave you with

two choices:

1) Use the new switch - This means you have to remove the old switch and install the

new one instead. While this is theoretically possible, it is a major pain in the butt, because

old AT-style cases are usually a pain to work with. And replacing the power switch is no

exception.

2) Use the old switch - This means you leave the old switch in the case. If you look at the

switch from inside the case, you'll notice that it has four different colored wires that run

to the power supply. Carefully write down what color wire connects to what pin, then

simply pull the wires off each pin. After installing the new power supply, remove the new

switch it came with and plug the four wires onto the pins of the original switch following

the color-coding you wrote down earlier.

Our recommendation: Go with the second option. Keep the old switch unless you have

reason to suspect it's bad and needs replacing. Using the old switch is a lot easier, and

doesn't require removal of the front bezel, trying to screw tiny screws into even tinier

plastic holes at impossible angles.

All set? Then close 'er up, plug in the power chord, push the power button and enjoy the

quiet hum of your new power supply providing your computer with the juice of life!

http://www.PCNineOneOne.com

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56 57

Sem comentários

Broadcast Tools DSC-20 Manual de Instalação Página 50