Broadcast Tools DSC-20 Manual de Instalação descarregar pdf (Página 48)

Preliminary 8-2002 RSHD Smartcaster Installation Manual

This is a typical ATX style motherboard power connector. You notice that on

one side it has a little clip that secures it in the socket on the motherboard. Make sure you

push this clip when removing it so you don't yank the entire socket off the motherboard.

Note: The older AT style connectors actually consist of two identical looking plugs 6-pin

plugs, usually labeled P8 and P9. They plug in right next to each other. Make a mental

note that the two black wires go next to each other in the center when you reconnect

them.

Now that you've disconnected all the cables from the power supply you can remove the

power supply itself. Look at the back of the case. There are four screws around the power

supply, on the outside of the cutout for the power supply. Remove the screws, but be sure

to grab the power supply with one hand and hold it in place when removing the last screw

so it doesn't drop into the case and damages any components. Carefully lift it out.

That's it. You just successfully removed the bad power supply. Wasn't that hard, was it?

And now that you're familiar with it and how it fits into the case, installing the new

power supply will be even easier.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 56 57

Sem comentários

Broadcast Tools DSC-20 Manual de Instalação Página 48