Broadcast Tools SS 2.1/Terminal III Especificações descarregar pdf (Página 22)

e-mail:

voice:

360.854.9559

fax:

866.783.1742

Site Sentinel

16 Installation and Operation Manual

SETUP

Relays

Relay label: Used to identify the device.

Alarms OFF: This option enables the sending of an email when the relay is OFF.

Alarms ON: This option enables the sending of an email when the relay is ON.

Email Addresses: This allows you to configure up to 8 emails to be sent whenever the

relay is turned ON or OFF.

Pulse: This is the number of milliseconds the relay will be toggled when

the pulse is activated.

NOTE: Pulse will toggle the relay, delay for the specified amount of time and then tog-

gle the relay again. If the relay is already on, Pulse will turn it off, delay then turn it

on.

Relays – Event Action Sequencer

Event action sequencer: Used to perform a relay function when other I/O devices are

within/outside the configured range.

Enable: Enables the selected input to monitor for each relay.

Action: When (meter, status, silence sensor, power failure or tempera-

ture) (input number) is (in ? condition) delay (xx) seconds then

engage for (xx) seconds.

Event action sequencer EXAMPLE: When (meter) (1) is (in High Alarm) delay (1) seconds

then engage for (2) seconds.

In the above example: When [metering input] [1] is [in high alarm] for more than [1] second,

(the desired relay) then engage for [pulse] 2 seconds.

NOTE: After any item has been changed, you MUST press the “Save Settings” button

for your changes to be saved.

WEBSITE:

Visit our web site for

product updates and

additional information.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Sem comentários

Broadcast Tools SS 2.1/Terminal III Especificações Página 22